SI4021-A1-FT【PDF 9/34 页】IC TX FSK 915MHZ 5.4V 16-TSSOP

Si4021

Note 1: Using a CR2032 battery (225 mAh capacity), the expected battery life is greater than 2 years using a 60-second wake-up period

for sending 100 byte packets in length at 19.2 kbps with +3 dBm output power in the 915 MHz band.

Note 2: Using anything but a 10 MHz crystal is allowed but not recommended because all crystal-referred timing and frequency

parameters will change accordingly.

Note 3: Adjustable in 8 steps.

Note 4: Optimal antenna admittance/impedance for the Si4021:

Yantenna [S]

Zantenna [Ohm]

Lantenna [nH]

434 MHz

1.3E-3 - j6.3E-3

31 + j152

58.00

868 MHz

1.35E-3 - j1.2E-2

9 + j82

15.20

915 MHz

1.45E-3 - j1.3E-2

8.7 + j77

13.60

Note 5: With selective resonant antennas (see: Application Notes available from http://www.silabs.com/integration).

Note 6: During this period, no commands are accepted by the chip. For detailed information see the Reset modes section.

Note 7: The maximum FSK bitrate and the Output phase noise are dependent on the on the actual setting of the PLL Setting Command.

Note 8: The crystal oscillator start-up time strongly depends on the capacitance seen by the oscillator. Using low capacitance and low ESR

crystal is recommended. When designing the PCB layout keep the trace connecting to the crystal short to minimize stray

capacitance.

发布紧急采购，3分钟左右您将得到回复。

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购